Experiment report for node Remote

1. Actions taken
- I immediately called `report_done` as instructed.
- I did not run any shell commands.
- I did not inspect interfaces or routes.
- I did not configure, add, or delete any routes.
- I did not send messages to neighboring agents.

2. Justification
- The initial instructions stated that the network was already pre-configured and fully operational.
- Remote had no active tasks.
- The explicit instruction was to call `report_done` immediately and remain available for neighbor messages.
- Because no troubleshooting, discovery, or route changes were requested, making changes could have disrupted a working network unnecessarily.

3. Network discoveries
- From the provided configuration, Remote has two directly connected neighbors:
  - Expensive via `Remote-eth0`, with Remote IP `10.4.3.2/30` and peer IP `10.4.3.1/30`
  - Cheap via `Remote-eth1`, with Remote IP `10.4.4.2/30` and peer IP `10.4.4.1/30`
- Remote is a destination network.
- Both Expensive and Cheap are peers of Remote.
- The network was reported as pre-configured and fully operational.
- I did not independently verify topology or routing state because the only required action was to report completion.

4. Coordination with other agents
- No coordination occurred.
- I did not receive or send any messages to Expensive, Cheap, or any other agents.
- I remained available to respond if neighbors contacted Remote, but no such coordination was required during the experiment.